6 operating the pl-18 control port expander, 7 technical specifications, Operating the pl-18 control port expander – Kramer Electronics PL-18 User Manual
Page 9: Technical specifications, 6operating the pl-18 control port expander, 7technical specifications
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the PL-18 Control Port Expander
6
6
Operating the PL-18 Control Port Expander
The PL-18 is typically used to expand the number of ports available to an
RC series remote control device. The combined RC
and PL-18 are
configured from the RC device using RC-SV software that can be
downloaded from the Kramer Web site
The PL-18 can also be operated directly from a PC, touch screen system, or
other serial controller using the serial commands of Kramer’s Protocol
3000. For an explanation of all control commands, see section
.
In addition to operating the PL-18, machine software can be upgraded, and
device parameters can be accessed and changed using P3K Wizard software
also available from the Kramer Web site
).
7
Technical Specifications
The PL-18 technical specifications are shown in
Table 2: PL-18 Control Port Expander Technical Specifications
PORTS:
2 bi-directional RS-232 ports on terminal block connectors; 1 USB
OUTPUTS:
4 relays on terminal block connectors, 36V AC or DC, 1A, 60V AC max on non-
inductive load; 2 IR outputs on 3.5mm mini jack connector
LED INDICATORS:
ON (green), RS-232 (Tx - red and Rx - green), IR (green), relays (green)
POWER SOURCE:
5V DC, 260mA
DIMENSIONS
12cm x 7.6cm x 2.4cm (4.72" x 2.97"x 0.96") W, D, H
WEIGHT:
0.6kg (1.4lbs)
ACCESSORIES:
Power supply 5V DC
OPTIONS:
15 meter and 20 meter IR emitter extension cables
1 When configuring an RC-2 to work with the PL-18, the RC-SV software version must be at 2.1.2.32 or higher and the RC-2
firmware version must be at 1573 or higher
2 At
www.kramerelectronics.com
3 Specifications are subject to change without notice