2 resetting the default edid, 3 connecting via the rs-232 port, 4 connecting via the ethernet port – Kramer Electronics VS-41H User Manual
Page 16: Connecting via the rs-232 port, Connecting via the ethernet port, And/o, Section 6.2.2
VS-41H - Operating the VS-41H
13
To acquire or change the EDID of a new output display:
1. Connect the new output display device.
2. Press the EDID button.
The INPUT buttons flash in sequence until the EDID is acquired.
6.2.2
Resetting the Default EDID
To reset the default EDID, disconnect the output and repeat the steps in
Section
6.3
Connecting via the RS-232 Port
You can connect to the VS-41H to a PC or RS-232 controller using the RS-232
connection.
Note that a null-modem adapter/connection is not required.
To connect to the VS-41H via RS-232:
•
Connect the RS-232 9-pin D-sub rear panel port on the VS-41H unit via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5
need to be connected) to the RS-232 9-pin D-sub port on your PC
6.4
Connecting via the ETHERNET Port
You can connect the VS-41H via the Ethernet, using a crossover cable (see
) for direct connection to the PC or a straight through cable (see
) for connection via a network hub or network router.
After connecting the Ethernet port, install and configure your Ethernet Port. For detailed
instructions, see the “Ethernet Configuration (FC-11) guide.pdf” file in the technical support
section on our Web site:
6.4.1
Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the VS-41H to the Ethernet port on your PC,
via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the VS-41H during the initial configuration.