Kramer Electronics VP-770 - Manual (Page 18)

VP-770 - Connecting the VP-770 13
13
6. Connect the audio input signals to the AUDIO IN connectors (3.5mm mini
jack and RCA connectors), as required (not shown in Figure 4 ).
7. Connect the PC VIDEO OUTPUT 15-pin HD connector to a VGA acceptor
(for example, an analog display).
8. Connect the HDMI VIDEO OUTPUT connector to an HDMI acceptor (for
example, a plasma display).
9. Connect the DGKAT RJ-45 connector to a receiver (for example, the Kramer
PT-572+).
10. Connect the SPKR Terminal Block connector to speakers (not shown in
Figure 4 ).
11. Connect the SPKR block connector to a pair of loudspeakers, by connecting
the left loudspeaker to the “L+” and the “L-” terminal block connectors, and
the right loudspeaker to the “R+” and the “R-” terminal block connectors. Do
not Ground the loudspeakers (not shown in Figure 4 ).
12. If required, you can connect a PC and/or controller to the:
 RS-232 terminal block (see Section 8.4 )
 Ethernet connector (see Section 8.5 )
13. Connect the power cord (not shown in Figure 4 ).