Kramer Electronics VP-747T - Manual (Page 16)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VP-747 using the VP-747T
14
8 Operating the VP-747 using the VP-747T
To operate the VP-747 via the VP-747T, set the VP-747 “Optimize T-bar”
mode in the “Transition” menu to On.
For details of how to operate the VP-747 via the OSD Menu, LCD Display,
ETHERNET, and/or RS-232, including using the TAKE button, refer to the
VP-747 user manual
1
• Use the WIPE DIRECTION buttons, see section
. For details of how to:
8.1
• Adjust the transition speed, see section
8.2
8.1 Using the VP-747T WIPE DIRECTION Buttons
To set the wipe direction, use the WIPE DIRECTION buttons
2
(see Table 3 ):
Table 3: Defining the WIPE DIRECTIONS Buttons
EFFECTS WIPE DIRECTIONS
Wipe
Choice of four
directions (only
one button is
selected)
Down Up Left to right Right to left
Diagonal
Choice of four
directions (two
buttons are
selected
simultaneously)
Circle
In Out
In Out
Square
In Out
In Out
Corner
Choice of four
directions (two
buttons are
selected
simultaneously)
Chessboard
In Out
Each block performs as shown
in the “Square” above
1 Download up-to-date Kramer user manuals from the Internet at: http://www.kramerelectronics.com
2 Item 18 in Figure 1 and Table 1