Kramer Electronics VP-441 - Manual (Page 15)

VP-441 - Controlling the VP-441 11
11
6 Controlling the VP-441
The VP-441 can be controlled via:

The front panel buttons (see Section
6.1
)

The OSD menu (see Section 6.2 )

RS-232 serial commands transmitted by a touch screen system, PC, or
other serial controller (see Section
6.3
)

The ETHERNET (see Section
6.4
)

The infrared remote control transmitter (see Section 6.5 )
6.1 Controlling via the Front Panel Buttons
The VP-441 includes the following front panel buttons:

Input selector buttons for selecting the required input: CV, YC,
COMPONENT (1 and 2), VGA or HDMI (1 and 2)

BLANK, MUTE and FREEZE buttons

MENU, ENTER, and up, down, left and right arrow buttons

RESET TO XGA/720p and PANEL LOCK buttons
6.1.1 The Auto Adjust (Auto Tune) Feature
The auto adjust feature (applies only to the VGA input) automatically centers the
image on the screen when pressing the ENTER front panel button or the OK button
on the remote control transmitter (when not within the OSD menu).
You can also implement this feature every time the input is switched to VGA or
when the input resolution changes, via the FINETUNE menu (see Section 6.2.2 ).