Chemglass 10L thru 20L Jacketed User Manual
Page 3
Overhead Stirrer Motor
Air Motor
1/4 HP Vertical Motor
1/4 HP Horizontal Motor Explosion Proof (XP) Motor
The motor is installed on the support frame when shipped. Use the following instructions should you need to remove or
adjust these components.
Components Needed for Overhead Stirrer Motor:
1ea
CG-2033-11
1/4 HP Vertical Electric Stirrer Motor
1ea
CG-2025-20
Air Motor* (Optional)
1ea
CG-2033-31
Digital Electric Stirrer Motor Controller (Only Supplied with 1/4 HP Electric Stirrer Motor)
1ea
CG-2044
Tru-Stir™ Stirrer Shaft Coupling
1ea
CG-9253-10
Small Kwik Klamp II
1ea
CG-3498-03
90
° Support Rod
1. The support frame has a universal motor mount. It can be used with an (vertical or horizontal) electric, air, or
optional explosion proof (XP) motor. The mount automatically centers the motor directly above the reactor.
2. The 1/4 HP electric motor is shipped attached to the support frame via four socket head cap screws.
3. When using the 1/4 HP electric motor, the digital controller, with mounting bracket on back panel, needs to be
mounted on the S.S. upright. Use the small Kwik Klamp II and the 90°S.S. support rod to mount the controller to
the support frame. Tighten all knobs securely.
*The Air Motor requires the air supply be filtered and a lubricator be installed between the air source and motor. Filter-
Regulator-Lubricator (CG-2025-10) is available separately.
www.cglifesciences.com