Chemglass 10L thru 20L Jacketed User Manual
Page 2
Read Entire Assembly Instructions Before You Begin. Familiarize Yourself with All of the Parts,
and Pay Close Attention to All Notes and Highlights.
Support frames are shipped via common carrier and require loading dock access with a fork lift or jack. If you
do not have a loading dock, then a lift gate-equipped truck must be requested at the time of order.
For your convenience, the jacketed process reactor, the fully assembled reactor head, stirrer shaft & agitators,
Tru-Stir™ stirrer shaft coupling, flake catching cup, PTFE stirrer bearing, temperature probe & adapter, S.S.
inlet/outlet adapters and motor are shipped assembled on the support frame. PTFE sleeves and keck clips are
available separately.
Unpack all of the parts and check against the packing slip to make sure you have received all necessary
components. If possible, keep some of the packaging materials from the wood crates in case you need to return
items for repair or replacement.
Crate # 1:
• Unpack the support frame with reactor and components by removing the plastic electrical ties that hold
the reactor in place and remove the cardboard/foam packing from around the reactor. Re-tighten all of
the Allen screws with the supplied wrenches, adjust all black knobs and tighten torque knobs. The red
silicone pad should be touching the straight section of the glass below the reactor flange. CHECK ALL
ALLEN SCREWS BEFORE PROCEEDING; SCREWS CAN LOOSEN DURING SHIPMENT.
• Attach the Tru-Stir™ stirrer shaft coupling to the 1/4 HP electric stirrer motor.
Crate # 2:
• Contains the condenser, zero dead space drain valve, temperature monitor, motor controller, and other
miscellaneous parts.
Move the reactor assembly and parts near the hood or area where the reactor will be used, but allow enough
space to move freely around the support frame. During setup, preparation, and process, it is best to keep the
wheels in their locked position by stepping down on the tab.
Black Knobs for
Vertical Height
Adjustment
Torque
Knobs
www.cglifesciences.com