Muxlab VGA 4x1 Switcher - Manual (Page 21)

© MuxLab Inc. VGA 4x1 Switcher Installation Guide
Page 21
Automatically loading a device detects the Switcher
connected to a PC, as well as the COM port on the PC to
which it is connected.
To load devices manually, select Devices>Add
Device… This loads devices one at a time, and does not
automatically detect the COM port on the PC to which
the device is connected. This COM port assignment
must be completed in the Configure Device tab. Until
this assignment is completed by the user, the loaded
device will appear in brackets as “offline” in the Devices
tree.
2. Configuring a Device
Configuring a device consists of three operations:
(i) Assigning a PC COM port to the device
(ii) Naming the device
(iii) Naming the four input ports on the device
To configure a device, select the device in the Devices
tree and click the Configure Device tab (Figure 14).
Figure 14: The Configure Device Tab