SawStop Job Site Cart - Manual (Page 4)

Assembling Your Job Site Cart
Fig. 3
Sa
w
St
op Sa
w
St
op
1
2
S
a
w
S
to
p 1
2
Fig. 2
Fig. 1
1. Locate all of the job site cart components shown on page 1. All of the hardware needed to assemble the job
site cart is located on the included hardware pack (see Fig. 1). In order to easily identify the hardware used in
each of the following steps, the different pieces of hardware are numbered on the hardware pack and in the
figures. If you are missing the hardware pack or any of the
other job site cart components, call the SawStop Service
Department at 503-682-6222 for replacements.
You will need the following tools to assemble the job site
cart:
• a 1 inch wrench or an adjustable wrench
• a 13 mm wrench
• a 17 mm wrench
• a 6 mm hex key
2. Insert one end of the wheel axle through
the axle hole in one side frame. Use
one 5 ⁄
8
lock washer and one 5 ⁄
8
inch hex
jam nut to secure the axle to the frame,
as shown in Fig. 2. Fully tighten the
nut using either a 1 inch wrench or an
adjustable wrench.
3. Repeat the same procedure to mount the other side frame to the other end of the wheel axle (see Fig. 3).
side frame
wheel axle
side frame
wheel axle
Job Site Cart Hardware Pack
6 Washers,
M16 x 32 (2)
1 Lock Washers, 5/8” (2)
Washers,
M17.5 x 40 (2) 4
Hex Jam Nuts,
5/8” (2) 2 Leveling Feet, 3/8” (2) 8
Button Head Socket
Bolts, M10 x 50 (4) 10
Lock Nuts, M10 (4) 11
Plastic Spacer (2) 3
Lock Nuts, 5/8” (2) 7
Socket Cap Bolts, M8 x 50 (4) 12
Lock Nuts,
M8 (4) 13 Wheel Axle
Spacers, (2) 5 Wing Nuts, 3/8” (4) 9
3 SawStop Job Site Cart
axle hole