SawStop Job Site Cart - Manual (Page 2)

1 SawStop Job Site Cart
Safety
1. Do not attempt to use or move the saw on an inclined surface. The weight of the saw makes it difficult to stop on
an inclined surface. Attempting to use or move the saw on an inclined surface could result in a severe injury.
2. Be sure to unplug or disconnect the saw from power before moving or repositioning it. The main power cord or
the power outlet could be damaged if the saw is not disconnected from power before moving it.
3. While moving the saw, only lift the job site cart handle to waist-height. Do not lift the handle higher or the saw
could tip on end.
4. Make sure the job site cart and saw are fully lowered to the ground and stable before operating the saw.
Otherwise, the saw could move unexpectedly and cause a severe injury.
5. Lower the saw slowly, do not let it drop back to the ground.
Note: If you have a SawStop 30” Out-Feed Table attached to your saw, you must remove it before using the job
site cart to move your saw or you can damage the out-feed table.
Warranty
SawStop warrants to the original retail purchaser of the job site cart accompanying this manual that the job site
cart will be free from defects in material and workmanship for ONE YEAR from the date of purchase. This warranty
does not apply to defects arising from misuse, abuse, negligence, accidents, normal wear-and-tear, unauthorized
repair or alteration, or lack of maintenance.
Please contact SawStop to take advantage of this warranty. If SawStop determines the job site cart is defective in
material or workmanship, and not due to misuse, abuse, negligence, accidents, normal wear-and-tear, unauthorized
repair or alteration, or lack of maintenance, then SawStop will, at its expense and upon proof of purchase, send
replacement parts to the original retail purchaser necessary to cure the defect. Alternatively, SawStop will repair
the job site cart, provided it is returned to SawStop, shipping prepaid, within the warranty period. This warranty is
void if the job site cart is modified without the prior permission of SawStop, LLC, or if the job site cart is located or
has been used outside of the country where the authorized SawStop distributor from whom the job site cart was
purchased resides.
SawStop disclaims any and all other express or implied warranties, including merchantability and fitness for a
particular purpose. SawStop shall not be liable for death, injuries to persons or property, or incidental, consequential,
contingent or special damages arising from the use of the job site cart.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
Note: Do not use the SawStop ® Job Site Cart with a saw having a 36” or 52” T-Glide TM Fence System attached.
A 36” or 52” fence system will change the balance of the saw and make the job site cart unstable. The job site
cart is designed to be used with the SawStop ® Contractor Fence Assembly only.