beautypg.com

Troubleshooting – Comfort-Aire VFH 24 CA User Manual

Page 20

background image

VFH InverterFlex

®

- Ceiling Cassette

Heat Controller

18

Troubleshooting

WARNING:

All service and maintenance should be carried out by an authorized servicer. Do not try to service

the unit yourself.

If you notice a malfunction has occurred (such as abnormal noises, smoke or burning smells), turn

off the power to the unit immediately and contact an authorized servicer.

Always disconnect power before performing any service or maintenance.

Some issues can be resolved without any maintenance to the unit, check the chart below to see if there is a
suggested solution to the problem before calling for service.

Problem

Cause

Solution

The unit will not operate at all.

Blown Fuse or tripped circuit

breaker.

Check the fuse or circuit breaker.

Replace the blown fuse or reset the

circuit breaker.

Power Failure

Wait until the power is restored to

restart the unit. If you experience

brown out conditions, contact an

electrician or your local utility.

Remote Control batteries are low

Replace the batteries. Be sure not

to mix old and new batteries, as

well as different brands/types.

Signal from remote control is not

being sent

Be sure that you are not using the

remote control too far away from

the indoor unit’s control panel.

The unit runs and then stops

immediately

Air inlets and/or outlets are

blocked

Remove any obstacles from the air

inlets/outlets

Clean the air filter, louvers, and

inlet grille.

Abnormal heating or cooling

Air inlets and/or outlets are

blocked

Remove any obstacles from the air

inlets/outlets

Clean the air filter, louvers, and

inlet grille.

Improper temperature is set

Ensure that the proper mode and

temperature is set on the unit. Try

to adjust the set point temperature

on the thermostat to a better

operating temperature.

Check the fan speed

Adjust the fan speed to see if that

improves the conditions.

Improper louver adjustment

Try to adjust the louver position to

ensure it is open enough.

Be sure that there are no other

sources of heat/steam in the area

being cooled

Remove or turn off other

appliances producing heat or

steam.

This manual is related to the following products: