Ellisse™ 6' x 48" whirlpool and bathing pool, High gloss, Revised 2/08 – American Standard Ellisse 2711.028WC User Manual

Page 2

H48

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP

OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.

■

REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.

OPTIONAL GRAB BAR KIT AVAILABLE AND MUST BE ORDERED SEPARATELY.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

●

IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH

CIRCULATING SYSTEM PIPING. MOUNTING HOLES DRILLED BY INSTALLER.

SUPPLY PIPING NOT INCLUDED.

ON SYSTEM II VARIATION: SYSTEM CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL A MINIMUM OF (152MM) 6"

ABOVE ROUGH FLOOR.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

1829mm

(72)

927mm

(36-1/2)

OUTLINE OF CUTOUT
1791 X 1181
(70-1/2 X 46-1/2)

C/L OF
DRAIN

102mm
(4)

PUMP

PROVIDE ACCESS

TO PUMP FOR SERVICE
ON ALL INSTALLATIONS

305mm

(12)

1219mm

(48)

229mm x 356mm
(9 x 14) FLOOR
CUTOUT

LEVELING STRINGER

(NOT FOR SUPPORT)

RECOMMENDED

FITTING

LOCATION
64X279mm
2-1/2 X 11)

1-1/2 N.P.T.M. THREADS

51mm

(2)

105mm

(4-1/8)

C/L OF
OVERFLOW

495mm

(19-1/2)

546mm

(21-1/2)

ROUGH

FLOOR

INTEGRAL

FEET

SUPPORT

1-1/2 O.D.TAILPIECE

OPTIONAL

DECK FITTING

AREA

GRAB BAR

FITTING AREA

64mm

(2-1/2)

121mm
(4-3/4)

SAFE-T-

HEATER
REMOVABLE

BLANK

GENERAL SPECIFICATIONS FOR 2711 WHIRLPOOL

72 x 48 x 21-1/2 In. (1829 x 1219 x 546mm)

148 Lbs. (67 Kg.)

965 Lbs. (434 Kg.)

95 Gal. (360 L)
74 Gal. (280 L)

43 x 28 In. (1092 x 711mm)
68 x 38 In. (1727 x 965mm)

14-5/8 In. (371mm)

40 Lbs./Sq.Ft. (195 Kgs./Sq.m)

30.3
60.8

2.1 HP, 15.6 AMPS ,120V.

SYSTEM II PUMP

WHIRLPOOL ELECTRICAL SPECIFICATIONS

INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT

)

Revised 2/08

ELLISSE™ 6' x 48"

WHIRLPOOL AND BATHING POOL

HIGH GLOSS