American Dryer Corp. SL31AD-15 - Manual (Page 27)

23
SECTION VI
INTRODUCTION TO PROGRAMMING
ALL programming is done through the keyboard (touch pad) selection buttons on the front of the control panel.
To change programs or to put the computer in the temperature or coin count display modes, the program switch
(PS) located on the back side of the computer must be put into the closed position (PSC).
The following instructions explain how to enter the program locations:
Dryer Off (Power On)
Display Reads
To enter temperature display
Display Reads
To enter program locations “Push” the Perm
Press keyboard (touch pad) selection button.
Display Reads
To advance to next program location “Push”
the temp selection keyboard (touch pad) button.
Display Reads
To speed up advance, “Push” and “Hold In”
HI Temp selection button.
Display Reads Program locations and will
advance until HI Temp selection button is released.
To revert back to lower program locations
“Push” LO Temp selection button.
and/or
(Close Program Switch)
(Amount To Start)
(Dryer Temperature Display)
FILL 25
75ºF
PL01
PERM PRESS
PL02
HI TEMP
HI TEMP
LO TEMP
PL03
PL04
PL05
(No Cycle In Progress)