Rugged Ridge Windshield Mount Light Bar, Textured Black, 07-14 Jeep Wrangler (JK) - Manual (Page 3)

Jeep® Windshield mount (5-tab) Light Bar. (2007 - UP ) 2DR and 4DR JK Wrangler
Page 3 of 3
11232.21 Rev (2) 2/24/10
Step 9. Reinstall (2) torx head bolts to front of lower mounting bracket. With all (6) torx head bolts
installed tighten securely to windshield frame. Tighten bolts in a clockwise rotation. Tighten M8
Allen head tube bolt. Repeat for other side.
Step10. Check all mounting bolts and light mounting nuts to insure they have been tightened before
driving vehicle.
P/N: 11232.21 Windshield Mount Light Bar
Step 8. Insert M8 Allen head bolt and M8 flat washer thought lower tube
connecting hole. Lower mounting bracket may need to be adjusted
to align holes. Attach M8 lock washer and M8 Nylock
nut to the back side of tube. DO NOT TIGHTEN at this time.
Repeat for other side.
Product information:
Your Rugged Ridge JK light bar has been designed to complement the body lines of your vehicle
and to work in conjunction with other Rugged Ridge accessories. Please visit our web site for our full
line of award winning products. http://www.omix-ada.com
Rugged Ridge Part Numbers:
11027.03 - Windshield Light Bracket (Black)
11028.03 - Windshield Light Bracket (Stainless)
11025.04 - Mirror Relocation Bracket (Black)
11026.04 - Mirror Relocation Bracket (Stainless)
NOTICE: Soft top operation with HID lights (15205.03)
When light bar is used with newer HID ( internal ballast) lights some contact with soft top may be
experirnced as the top is raised or lowered. To lower the top simply release all attachment points as
normal. Before lifting the front header release the two center latches that hold the middle of the top
down. Raise the center slightly. Lift and tilt front header back until top has cleared light housings.
Installing top is the reversal of lowering. Center latches must be locked before securing front header.