Rugged Ridge Windshield Mount Light Bar, Textured Black, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

Jeep® Windshield mount (5-tab) Light Bar. (2007 - UP ) 2DR and 4DR JK Wrangler
Page 2 of 3
11232.21 Rev (2) 2/24/10
Step 5. It is recommended that lights be installed to top light bar prior to
placing on lower mounting tubes. All lights should be wired through
pre-drilled grommet holes located under mounting tabs. With lights
installed fish wires out bottom of top tube. Wire disconnects should
be installed on all wires at this time. When top light bar is placed onto
lower mounting tubes wires can be connected to ease installation.
NOTICE: All pre-drilled holes with grommets should be sealed using
a quality automotive sealant. If needed grommets can be removed
but tube must be sealed after wires have been installed.
Step 6. With the help of a second person, lift top light bar into position.
Check to see if light mounting bolts are close or making contact with
top of windshield frame. If it appears any of the mounting bolts are
to long cut length as needed. Failure to do so may result in
damage to vehicles finish.
NOTICE: The JK light Bar has been designed to sit low along the top
of the windshield to reduce wind noise and buffeting of soft-tops.
Some light manufactures have longer mounting bolts that will require
modification to allow installation.
Step 7. With lights mounted install top light bar with the help of a second person. Attach wire connectors
and place onto lower mounting tubes. Lower mounting brackets may need to be pulled outward
to allow top tube bar to slide into position.
P/N: 11232.21 Windshield Mount Light Bar
Step 4. Place new lower mounting bracket on windshield frame. Install and
leave loose the (4) outer bolts only. DO NOT install the (2) front
bolts at this time. Lower mounting brackets must remain loose for
top light bar to be installed. Repeat on other side.