Rugged Ridge Front Headrest Grab Handles, Red, 07-14 Jeep Wrangler - Manual (Page 3)

Front Windshield installation of 13305.14 and 13305.15
Step 1 – Because the windshield upper bolt is located behind the side frame
plastic trim it is recommended that you place a business card
slightly bent, between the upper side trim and the dash panel
(see Fig.7). In case you loose the bolt from the socket during
removal or installation the business card will keep the bolt from
falling into or behind the dash assembly.
Fig.7 Fig.8
Step 2 – Using a ½” socket remove the upper side bolt (Fig.8). Be careful to
not drop the bolt inside of the plastic side trim. See step 1 for tip.
Fig. 9
Step 3 – When unscrewing bolts take care to not hit your windshield with
your wrench. Place hand over handle as shown (Fig.9)
Step 4 – Using the same socket remove the inner most sunshade retainer bolt
(fig.10). Add supplied washer and insert through grab handle as
Shown. (Fig.11). Reinsert into sunshade mounting hole and tighten.
Pg.3