beautypg.com

Rugged Ridge Fender Flare Kit, 10-14 Ram 2500 and 3500 Pickups User Manual

Page 4

background image

Copyright © 2013 Omix-Ada

®

, Inc.

460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]

All Terrain Flares 10-14 Ram 2500/3500

9. Hold flare to vehicle and start supplied Phillips
screws and factory bolts into existing holes and
holes covered in plastic tabs and clips.

Do not

tighten. Press firmly on flare and tighten all screws.
Complete rear flare installation.

7. Remove six factory installed screws with 8 mm sock-
et wrench. Save factory screws for installation. Do not
remove factory screws marked with X’s.

8. Install plastic tab over existing factory hole like
Step 5. Install Screw Clip over inner lip edge of fend-
er centered over plastic tab. Install flare using sup-
plied Phillips Screws. Moderate pressure against the
flare may be needed for mounting holes to align.

Page 4/5

81630.43