beautypg.com

Rugged Ridge Fender Flare Kit, 10-14 Ram 2500 and 3500 Pickups User Manual

Page 2

background image

Copyright © 2013 Omix-Ada

®

, Inc.

460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]

All Terrain Flares 10-14 Ram 2500/3500

3. Remove four factory installed screws with 8 mm
socket wrench. Save factory screws, they can be
used in installation. Remove plastic piece at bot-
tom rear of wheel well (2011-2014 only).

1. Install supplied bolts, washers, and locking nuts into
each flare.

2. Clean inside of top lip edge with rubbing alcohol.
Install edge trim by removing red vinyl tape covering
only a few inches at a time. Applying adhesive side
of edge trim to inner side of flare. Install edge trim to
the top edge of flare (the edge that contacts ve-
hicle). Do not stretch trim while being applied. Trim
excess from ends.

Page 2/5

81630.43

Inner Flare Surface

Washer

Bolt

Nut