Rugged Ridge All Terrain Fender Flares, 09-12 Ram 1500 Trucks - Manual

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN
Page 1 of 3 Rev. 11/10 SB
81630.42
CONTENTS:
1. Fender Flares (4)
2. M8 Socket Head Cap Crews (40)
3. M8 Flat Washers (40)
4. M8 Locking Hex Nuts (40)
5. #10 U - Clamps (6)
6. Phillips Head Screws (6)
7. Roll of edge trim
Dodge Ram All Terrain Flare Kit 2009-2012
Step 1. Install the supplied decorative cap screws onto the flares.
Place a washer on the bolt and insert the bolt through
the hole in the flare. Place a lock nut onto the back side
of the flare to secure the bolt. Repeat for all hole
locations.
Step 2. Install the edge trim onto the flares. Clean inside
mounting lip edge with rubbing alcohol. Install edge
trim as shown by removing red vinyl tape covering only
a few inches at a time. Do not stretch the trim while
being applied, this may cause shrinkage after installation.
Trim excess off.
Step 3. Remove factory screws located in front wheel well
housing as indicated by the large arrows in the image.
Do not discard the factory hardware it will be reused to
attach the fender flare. Install one of the U clamps in the
area indicated by the small arrow.