Rugged Ridge All Terrain Flat Fender Flare Kit, 07-14 Jeep Wrangler User Manual

Page 2

Page 2 of 3

JK All-Terrain Flat Fender Flare Kit

11620.10

Install the rubber bumper to the factory bracket that extends out from

under the front driver side fender using the supplied M8 bolt, M8 standard nut,

M8 lock nut and 3 flat washers. Place the M8 bolt through the top hole on the

rubber bumper. Place a washer and hex nut on the bolt extending through the

rubber bumper. Slightly tighten. Place a washer on the bolt, insert into

the factory bracket. Using a washer and locknut on the bottom side of the

bracket, secure the rubber bumper to the bracket. Repeat for passenger side.

Mount the front driver side flare using the supplied M6 bolts, flat

washers and flange nuts. Keep fasteners loose until all mounting bolts are

installed. Tighten bolts to secure the flares into position. Repeat for passenger

side flare. NOTE: If installing JK Wheel Liners (P/N 11620.50), it is only

necessary to install the top 2 bolts at this point. Please refer to the Wheel Liner

instructions to complete front flare installation.

Place factory side marker into supplied plastic light bracket. Place the metal retainer on the back of the

side marker and push downward to secure the side marker into the bracket as shown. Repeat for RH side marker.

NOTE: This step is not necessary if also installing JK Wheel Liners (P/N 11620.50). NOTE: For ease of installation

of the side marker retainer, it may be necessary to make slight bends on the four tabs of the Side Marker Retainer

with pliers as shown below.

Install the LH side marker bracket under the front driver flare using one

factory bolt removed in step 3 and one supplied M6 bolt, flat washer and

flange nut. Repeat for RH side bracket. NOTE: This step is not necessary if also

installing JK Wheel Liners (P/N 11620.50).

6/30/10