Rugged Ridge Upper Door Kit, Rear, Black, 07-14 Jeep 4-Door Wrangler (JK) - Manual (Page 6)

P age 6 of 6
28. With door closed inspect outside alignment. If upper door is not centered and/or has more than a 1/8” gap at
the top corners the frame will need to be readjusted using adjustment collars starting with lowest corner first.
29. With door centered tighten set screws and readjust Velcro to door. Check for visible light from inside vehicle.
If light is present repeat steps (22-29).
Pic. 31
Features and Functions of Soft Upper Doors
For assistance, please contact Omix-ADA Technical Support department
(770) 614-6101
[email protected]
© Copyright 2011, Omix-Ada
26. With rear doors aligned open and close doors several times. As the rear door closes the upper door front corner
should rest on door frame and slide into place (Pic. 31). This contact with rear door frame insures a weather
tight seal and is considered normal.
Pic. 32 Pic. 33
Rugged Ridge upper door windows can be set in 3 new distinct positions. By unzipping the window and sliding
plastic dowels through the elastic straps the door can be configured as shown.
Half Fold Rear Fold Front Fold
This feature will allow air flow to be tailored as needed and will prolong the life of the upper door fabric,
zipper and plastic window.
27. If upper door falls below plastic surround or binds as door closes (Pic. 32) the upper door will need to be bent
back away from vehicle ( Pic. 33). (DO NOT OVER BEND) Small adjustments should be made until proper contact
with door frame is achieved.
30. Trim weather stip as discribed in step (21).