Rugged Ridge Rear Tube Doors, Textured Black, 07-14 Jeep Wrangler Unlimited (JK) User Manual

Page 2

Page 2 of 2

To ensure the rotary latch is aligned properly with factory door

striker, loosen the (4) bolts securing the rotary latch to the Tube Door to

allow for adjustment. With the rotary latch in the open position, line up

the notch in the latching mechanism with the factory door striker and

close the door. It may be necessary to loosen the factory door striker for

proper alignment. If so, be sure to replace door striker to its original

position before re-installing factory doors. When proper alignment is

achieved, tighten door latch bolts. Open and close the door repeatedly

to make sure door is secure and functioning properly. Repeat for

passenger door.

Attach the loop of the Adjustable Nylon Strap to the hook on the

Tube Door and the hook inside the vehicle. By using different loops to

attach to the vehicle hook, the amount of door opening can be adjusted.

CAUTION ! To avoid risk of injury latch mechanism must be properly adjusted before use. Inspect and adjust as

necessary should wear alter alignment of latch and striker. Do not use door/latch if damaged.

With tube doors installed, hold Anti-Rattle Bumper between the

door and vehicle door jamb. Close the door and adjust the location of

the bumper to achieve a snug fit. Mark the location of the Anti-Rattle

Bumper using tape. Open door and mark the center of the bumper with

a center punch to prepare for drilling.

Drill a 3/32” hole and attach the bumper with the supplied sheet

metal screw. Do not overtighten. The attachment screw can be

loosened or tightened as necessary to adjust the length of the Anti-

Rattle Bumper.

OPTIONAL RUBBER BUMPER INSTALLATION

After installing Tube Doors, optional Anti-Rattle Bumpers can be installed.

For assistance, please contact Omix-ADA Technical Support department

(770) 614-6101