Rugged Ridge Half Doors, Front, 07-14 Jeep Wrangler (JK) - Manual (Page 4)

Page 4 of 4
JK FRONT HALF DOORS
11509.01 JK Front Half Doors
PAINTING INSTRUCTIONS FOR EXTERIOR DOOR SURFACE
Rugged Ridge Half Doors are designed to be painted or used as is. Painting will enhance the look of the doors
while increasing the life of the product. Follow the instructions below for proper painting technique.
1. Remove door hinges before painting. Using painters tape, cover sections of door that should not be
painted including the inner door panel and door latch.
2. Wet sand the surface of the exterior door panel with 400 grit wet sand paper to smooth the surface and
remove any imperfections.
3. Use a mild detergent and clean cloth to clean and remove surface contaminants from the door panel. Be
sure all cleaning agents have fully dried from the surface of the door before proceeding. Thorough cleaning
of the entire surface of the exterior door panel is imperative to achieving a quality finish.
4. Apply adhesion promoter to the clean dry surface of the door. Follow the manufacturer’s instructions
for proper application and allow product to fully cure before proceeding.
5. Prime the surface using a primer formulated for plastics. Follow the manufacturer’s instructions and
allow primer to fully dry.
6. Wet sand the door panel with 1000 grit wet sand paper until surface is smooth.
7. Wipe the door panel down with a wax and grease remover to remove any surface contaminants and let
door panel dry completely.
8. Wipe clean dry surface of the door panel with a tack rag to remove any dust particles before applying
top coat.
9. Apply top coat using automotive grade paint. Follow the manufacturer’s instructions. Apply multiple
coats if necessary. Note: Applying a clear coat will improve finish and protect against wear and tear.
10. Let top coats dry completely. Wet sand the painted surface with 1500 grit wet sand paper followed by
3000 grit wet sand paper. Note: Polish and wax after wet sanding for optimum surface finish.
For assistance, please contact Omix-ADA Technical Support department
(770) 614-6101
[email protected]
© Copyright 2010, Omix-Ada
THE FOLLOWING ACCESSORIES ARE DESIGNED FOR USE WITH JK HALF DOORS:
Rugged Ridge Soft Upper Doors Front (part number 13711.15)
Rugged Ridge Soft Upper Doors Rear (part number 13712.15)
Rugged Ridge replacement JK Mirrors (part number 11002.21)
11. Apply Logo to the oval recess located in the lower rear corner of
the door. Be sure the surface of the door is cleaned thoroughly and dry
before Logo is applied. NOTICE! If doors will be painted, do not attach
Logo until the last coat is applied and fully cured.