beautypg.com

Rugged Ridge Cold Air Intake Kit, 3.8L, 07-11 Jeep Wrangler (JK) User Manual

Page 3

background image

Page 3 of 3

6. Secure air tube to rubber isolator. Loosen all hose clamps to allow for movement of tube. Place large

2.5" hose clamp over air filter and install filter to air tube from inside heat shield.

7. With tube secured to heat shield and filter installed tighten all hose clamps. reconnect breather tube

back onto intake tube. Two small hose clamps have been provided to insure a tight fit to intake tube.

Attach weather stripping to top of heat shield. Cut to fit.

8. Double check all hose clamps to insure there are no air leaks before driving.

Secure tube to heat shield

Install filter to intake tube

Secure hose clamps

Connect breather hose with clamp

Install weather stripping

© Copyright 2009, Omix-Ada

Omix-Ada Inc.

460 Horizon Dr. Suite 400

Suwanee, Georgia 30024

Note: This filter is polyester synthetic and never needs to be oiled. It can de cleaned with warm

water and mild detergent dish soap.

9. Congratulations on the purchase and installation of another quality Rugged Ridge product.