beautypg.com

Rugged Ridge XHD Aluminum Front Bumper, Winch Mount User Manual

Page 2

background image

Page 2 of 2

For Technical Assistance Contact:

OMIX-ADA Tech Support

Phone: 1-800-449-6649

Email: [email protected]

Web: www.Omix-Ada.com

Rev. 8/11

4. Place Center Section of Bumper onto the frame rails. Align the holes and place the rubber isolator gasket

between the bumper and D-rings. Using the supplied M12 bolts, place a washer on each of the bolts and

insert them thru the D-rings and into the bumper. Note: The D-ring bolt holes are wider on the top.

5. Install the L-bracket nut plates on the back side of the bumper with the L portion on the bottom. Tighten

both top and bottom bolts in small increments evenly on each nut plate.

6. Reconnect the fog lights.

SB

© Copyright Omix-Ada 2011

7. Install the top cover plate using the (4) pan head screws with a nut and washer on the bottom of each.

8. Install the (6) plastic filler plugs in each of the three holes on each side of the bumper.