Rugged Ridge XHD Aluminum Front Bumper, Winch Mount - Manual

11541.01
11541.02
JK Wrangler Modular XHD Aluminum Front Bumper
Contents:
1. Bumper Center Section (1)
2. D-Ring (2)
3. Top Cover plate (1)
4. M12 x 60 Bolt (8)
5. M12 Washer (8)
6. M12 Lock Nut plate (4)
7. Plastic plugs (6)
8. Rubber Isolator Gasket (2)
9. M8 Countersunk Screw (4)
10. M8 Flat Washer (4)
11. M8 Hex Nut (4)
Optional Accessories shown:
(Not included)
-Hoop Over rider (11541.14)
-Stubby Ends (11540.10)
-Winch Plate (11541.13)
1. Remove the factory front bumper. First disconnect the fog lights by twisting the plug in the rear of the
light housings. Next remove the factory air dam. Remove the 4 nuts per frame horn that hold the
original front bumper to the vehicle.
3. Install the original fog lights into the Center Section from the back. Use the factory screws to secure
the fog lights into the new bumper.
Page 1 of 2 Rev. 8/11 SB
Note: When purchasing optional accessories, refer the accessory instructions first before installation of
the bumper center section. The bumper will need to be removed for some accessories.
2. Remove the factory fog lights from the bumper. Do not discard the screws as they will be re-used.