Asoka Pluglink PL9950-BBR - Manual (Page 11)

Asoka® User’s Guide
PlugLink 9950 Cable/ DSL Router PL9950-BBR
Page 11 of 43
Chapter 5
Installing the PlugLink 9950 Cable/ DSL Router
Note: Do not connect the PlugLink 9950 Cable/ DSL Router to a power strip, extension cord,
uninterruptible power supply (UPS), or surge protector. This may prevent the unit from working
properly or degrade the network performance.
Note: Shut down any programs that are running on your computer prior to installing the PL9950-
BBR Router.
1. Connect the modem via an Ethernet cable supplied by your modem manufacturer into the
port labeled WAN on the bottom of the 9950 Cable/ DSL Router.
2. Connect your computer into the LAN port on the bottom of the 9950 Cable/ DSL Router
using the supplied Ethernet cable.
3. Plug the PL9950-BBR directly into an available power outlet.
4. Plug in your modem and restart your computer.
Figure 5-1: Diagram of the hardware setup.
5. Check the LEDs on the front panel of the PL9950-BBR Router. All four LEDs should be either lit
or blinking intermittently.