Brocks Performance ShortMeg Full System 14" Muffler CBR-1000RR (12-14) User Manual
Page 6
Document ID 996512
Page 6 of 6
Step 10: Clean System of Finger Prints:
With any exhaust system you must clean all oil and finger
prints off before starting the motorcycle to ensure there will not be finger prints “burned” into the exhaust.
Carefully use a mild cleaner such as Original Bike Spirits spray polish & cleaner.
Step 11: Re-attach Radiator Bracket:
To re-attach the radiator to the lower bracket, insert the screw
removed earlier in the bottom radiator mount and tighten.
Step 12: Install Bodywork and Check Clearance:
Re-install the bodywork in the reverse order
that it was removed and check for clearance between exhaust and bodywork.
Bodywork must be at least ¼
of an inch from any part of the exhaust system.
Brock’s Performance does not warrant burned plastic.
Additional:
Perform the air valve block off modifications detailed in the instructions included with your
purchase. Install the appropriate Power Commander & map for your application.
***CAUTION: PAIR BLOCK OFF MUST BE PERFORMED IN ORDER TO
PREVENT PREMATURE EXHAUST FAILURE. PLEASE REFER TO THE PAIR
BLOCK OFF INSTRUCTIONS THAT WERE INCLUDED OR FIND THEM AT
BROCKSPERFORMANCE.COM. FAILURE TO PERFORM THIS
MODIFICATION WILL VOID PRODUCT WARRANTY***
All Brock’s Performance products are designed for closed-course racetrack use ONLY!
For more information on Brock’s Performance Warranty and Terms and Conditions: www.BrocksPerformance.com
> About Us > Terms and Conditions
For Questions and Comments: www.BrocksPerformance.com > Customer Service > Contact Us
or call the Tech Line 937-912-0054