Brocks Performance ShortMeg Full System 14" Muffler CBR-1000RR (12-14) - Manual (Page 2)

Document ID 996512
Page 2 of 6
Step 3: Remove Bodywork:
Start with removing the air duct cover (outside of air duct tubes), each side
has two (2) Phillips head screws and one (1) hex head screw (see figure 3.) Remove the air intake cover (below
headlamps) with three (3) plastic fasteners/snap rivets (see figure 4.) Remove the lower cowl, two (2) hex head
screws on each side and slide rearward to release clips (see figure 5.) Remove middle cowls, one (1) hex head
screw on each side and one (1) plastic fastener/snap rivet on the inside of each cowl, gently pull each outward,
detaching the tabs from the upper cowl to remove (see figure 6.) Refer to the factory service manual for more
detailed instructions.
Step 4: Remove Muffler: Remove the exhaust valve cable. Under the tail next to the passenger foot peg,
remove the small cover with three (3) plastic fasteners/snap rivets (see figure 7.) Turn the pulley clockwise and
remove the cable (see figure 8.) Replace the cover. Remove the O2 sensor by unscrewing it from the muffler (see
figure 9) and unplugging it from the connector on the left hand side of the bike, under the frame (see figure 10.)
Loosen the muffler clamp bolt; it only needs loosened, not removed (see figure 11.) While supporting the muffler,
remove the nut and bolt assembly securing the muffler to the muffler-mounting bracket (see figure 12.) Release
the exhaust valve cable from its clips. You can now remove the muffler by gently sliding it rearward while
supporting its weight.