Brocks Performance Window Link Set ZX-14 (06-15) User Manual
Window link set adjustment consistency
Document ID 996447
Page 1 of 1
Brock’s Performance • 4064 E. Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062
Window Link Set Adjustment Consistency
***It is imperative that you ensure your window links are adjusted to within .010” of each other PRIOR to
operating your motorcycle. If they are not adjusted properly DO NOT OPERATE your motorcycle.***
•
Laser etched “L” /Arrow shows direction to turn wrench to lower bike. Remember L = LOWER. (Links adjust
LONGER to make the bike LOWER. Opposite direction to raise bike.)
•
Coarse Adjustment: Count the same number of flats on the adjustment rods on each link to adjust ride height.
See individual link instructions for more information.
•
When making adjustments, do not adjust one side more than one complete revolution without adjusting the
opposite side as well.
•
We highly recommend using a set of calipers to measure the length of each rod as seen below. Measure each
side of the lowering links and confirm that they are within .010” of each other before operating your motorcycle.
***Links have been removed from bikes for clarity; however, adjustments are to be made when installed on bike***
All Brock’s Performance products are designed for closed-course racetrack use ONLY!
For more information on Brock’s Performance Warranty and Terms and Conditions: www.BrocksPerformance.com > About Us > Terms and Conditions
For Questions and Comments: www.BrocksPerformance.com > Customer Service > Contact Us or call the Tech Line 937-912-0054.