Martin Universal Design U-DS90W Creation Station - Manual (Page 4)

6
8
C
C
B
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
STEP 5] Attach Drawer Units to Base
Assembly Instructions:
Revised June 07- RPI
Pg. 4
Attach the drawer units to the table base as illustrated below
using [4] M4.2 x 16mm screws (part E) for each drawer unit.
See FIG 5 below.
STEP 6] Attaching Tilt Supports to base
Attach the [2] Tilt Supports (part #8) to the Top Surface Cross
Support (part #6) using [2] M6 x 13mm Allen Bolts (part A) in
the upper portion of the tilt support and [2] 1/4” x 35mm Allen
bolts (part C) and secure with [2] nuts (part B). SEE FIG 6.
5
5
5
5
12
12
FIG 5
FIG 6
STEP 7] Attach L-Bracket to Base
Take the L-Bracket (part #11) and insert the pin that is at-
tached to the L-Bracket into the hole on the inside section of
the upper base end. Repeat with other side.
NOTE: This L-bracket has two holes which are used to
attach to the bottom of the top with [2] Allen M6 x 13mm
bolts per L-bracket. See Step 9.
11
STEP 8] Attaching Tilt Supports to Top
8
C
C
STEP 9] Attach L-Bracket to Top
Complete Top assembly by attaching L-Brackets to Top using
[2] M6 x 13mm Allen Bolts and securing them into T-Nuts
found on the underside of Top. Tighten with Allen Wrench.
Turn table back onto
its castors for use.
Lift up on back edge
of top to tilt surface.
Attach the [2] Tilt Supports (part #8) to the Top (part #1) us-
ing [2] M6 x 13mm Allen Bolts (part A) into the T-Nuts found
on the underside of the Table Top (part #1). Tighten with
Allen Wrench. NOTE: This step is easier if you place the
assembled base upside down onto the table top on a
carpeted surface. Have [2] people help lifting and turn
the base upside down.