Martin Universal Design U-UDS5000WD Drawing Table - Manual (Page 2)

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
U-UDS5000WD Drawing Table Assembly Instructions
STEP 1] Assembly Base of Table
Begin by taking the [2] Lower Base Feet (part B)
and attach the foot rest (part C) to the Lower Base
Feet using [2] M4 x 12mm screws (part 1). Secure
by tightening screws. See FIG 1.
Continue by sliding the H-Frame (part D) down
into the sides of the Lower Base Feet (part B).
Secure with large washer (part 7) and Knob (part
5). Tighten Knob to secure.
Complete Step 1 by inserting [4] Threaded Rubber
Feet (part 8) into the bottom of the base.
See FIG 1.
D
FIG 1
STEP 2] Hinges to Base Assembly
FIG 2
B
Pg. 2
Aug. 08 Revised- RPI
C
5
8
7
1
1
5
B
8
Attach [3] Hinges (part 9) to the top edge of the
H-Frame (part D) by using [2] M4 x 12mm screws
in each hinge as shown in FIG 2.
Secure to H-Frame with Phillips screw-driver.
IMPORTANT: ASSEMBLY IS EASIER AND SAFER WITH TWO PEOPLE