Martin Universal Design U-HL6080W ARIEL TABLE - Manual (Page 3)

FIG 3
Q
C
Q
Martin Universal Design, Inc. • Detroit, MI 48208 USA
Tel: 1-313-895-0700 • E-mail: [email protected] • www.MartinUniversalDesign.com
Insert 1 ea. Locking Castor (Part L) into
each of the two front holes found on
the bottom of each leg (Part A & B)
Insert 1 ea. Castor (Part K) into each of
the two rear holes found on the bottom
of each leg (Part A & B)
See FIG 1
Step 1. Attach Castors to Left and Right
Legs
L
FIG 1
3 2/28/11- RPI
Ariel Table Assembly Instructions:
FIG 3B
B
A
K
L
M
E
Step 2. Insert Cam Locks into Base
Shelf
Insert 4 ea. Cam Locks (Part M) into
each of the holes found on the bottom
side of the Base Shelf (Part E), making
sure holes line up with holes in shelf
edge.
See FIG 2 FIG 2
Step 3. Attach Cross Member to ea. leg.
Attach Cross Member (Part C) to each
leg using 2 each Hex Bolts (Part Q).
Thread the Hex bolt through the side
of each leg and into the cross member
holes.
DO NOT TIGHTEN at this point, keep
the bolts slightly loose.
See FIG 3
Step 3B. Attach Base Shelf to Base
E
Q
Q Attach White Base Shelf (Part E) to
base using 2 each Hex Bolts (Part Q) in
each end of Shelf. TIGHTEN using
Allen Wrench (Part W). Repeat with
other side. See FIG 3B
NOW go back and TIGHTEN CROSS
MEMBER HEX BOLTS (STEP 2) with
Allen Wrench (Part W).