Minka Group F702-VB - Manual (Page 6)

A
SSEMBLING THE
F
AN
4.
Your fan is packed with the motor
and Upper Housing unassembled,
proceed the following steps for fan
assembly:
Step1. Remove the two screws and
rubber washers from the top of the
motor center band. Place the upper
housing over the motor center band
and secure it with the two screws and
rubber washers previously removed.
(Fig.5)
Step2. Engage the white wire
connectors from the motor and the
bulb holder assembly make sure the
connection is secured Follow the same
procedure for the orange and black
wire connectors.(Fig.6)
Step3. Loosen the three screws (do
not remove) from the motor
coupling.(Fig. 7)
Step4. Place the bulb holder assembly
key holes over the 3 screws previously
loosened
from the motor coupling, turn the
bulb holder assembly until it locks in
place at the narrow section of the key
holes. secure by tightening the three
screws previously loosened.(Fig.7)
Fig. 5
Screw
Motor
center
band
Top motor
Upper housing
Fig. 6
Wire
connectors
Screws
Fig. 7
Motor
Motor
coupling
Bulb holder
assembly
Bulb holder
assembly
Motor
Rubber
washers