Perating the, Ransmitter – Minka Group F702-VB User Manual
Page 13

11.O
PERATING THE
W
ALL
T
RANSMITTER
Restore power to ceiling fan and test for
proper operation.
A. HI, MED, and LOW buttons:
These three buttons are used to set
the fan speed as follows:
HI= high speed
Med= medium speed
Low= low speed
B. FAN OFF button:
This button turns the fan off.
C. D/L button:
This button controls the down light.
D. U/L button:
This button controls the up light.
Press and release the button to turn the
light ON or OFF. Press and hold the
button to set the desired brightness. The
light key has an auto-resume, it will stay
at the same brightness as the last time it
was turned off.
Speed settings for warm or cool
weather depend on factors such as the
room size. Ceiling height, number of
fans, etc.
The Reverse switch is located on the
top of motor assembly. Slide the
switch to the Left for warm weather
operation. Slide the switch to the Right
for cool weather operation.
NOTE: Wait for fan to stop before
changing the setting of the slide switch.
Fig 22
Fig 23
SUMMER OPERATION
WINTER OPERATION
Warm weather - (Forward)
A downward airflow creates a cooling
effect as shown in Fig. 22. This allows
you to set your air conditioner on a
warmer setting without affecting your
comfort.
Cool weather - (Reverse)
An upward airflow moves warm air
off the ceiling area as shown in Fig. 23.
This allows you to set your heating unit
on a cooler setting without affecting
your comfort.