Magikitch'n FM - Manual (Page 7)

Installation
GAS CONNECTION
An adequate gas supply is required for proper broiler
performance. With all burners on “HIGH”, the manifold
pressure should not show any appreciable drop.
Fluctuations of more than 25% will create pilot problems
and affect burner operation.
WARNING!!
This unit must be connected ONLY to the type
of gas specified on the rating plate.
1. Remove the hairpin clips securing the burners. This
will allow for removal of the burners for inspection,
cleaning and servicing.
2. Attach the regulator supplied with the unit. The
regulator must be installed at the entry end of the gas
manifold.
NOTE: Be sure the regulator is installed so that the
gas flows in the same direction as the
arrow on the bottom of the regulator. Use
the supplied regulator only. Use of any
other regulator will invalidate the
warranty.
3. Adjust the regulator to the burner pressure listed on
the rating plate. Refer to the table on the following
page for proper pressure settings.
NOTE: A pressure regulator is not required for all
countries.
4. Use pipe joint compound suitable for use with LP
gas on all threaded connections.
5. Turn off all burner valves.
6. Turn on the gas supply. Check all connections for
gas leaks using soap and water. Never use an open
flame to check for gas leaks!
GAS CONVERSION
All units are shipped with the appropriate orifices and
components required for the gas requested. If the unit
does not perform well or has unsatisfactory flame
characteristics (too high, yellow tips, lifting), check that
the supply pressure and orifice size are appropriate for
the gas used before making any adjustments.
Use the following directions to convert the unit to a
different type of gas if necessary. Each conversion kit
contains all the orifice sizes and markings required for
converting any size unit to any gas type in all countries.
Note that in Belgium units may not be converted. For
some conversions it may also be necessary to replace the
regulator or restrictor orifice.
NOTE: Refer to the table on the following page to
determine gas requirements, pressure settings
and orifice sizes.
1. Shut off the gas supply to the unit.
2. Disconnect the unit from the gas supply.
3. Remove the top grids, radiants, runner tubes and
burners.
4. Remove the brass runner tube orifice. Replace with
the new orifice.
5. Remove all burner orifices. Replace with the new
orifices.
6. Adjust the air shutters on all the burners to the
correct opening. Mark the air shutter at the correct
setting. Re-install the burners.
7. Re-install the runner tubes, radiants, and top grids.
8. Adjust the regulator to the correct gas pressure. If a
restrictor orifice is required in place of the regulator
to meet your countries specific codes, remove the
old restrictor orifice and replace it with a new one
correctly sized to provide the burner pressure
specified for the gas type being used.
9. Adhere the appropriate conversion sticker to the
front of the unit, near the rating plate.
31-01-12962 rev B L25-004 1 rev 0 5-2001 3
rev 1 (05/11)