Varad Scanners® - Scanners® Styles: VS400, VS4000, VS5000 - Manual

Whenever SCANNERS™ is active, press the "pattern select" button once to select the next pattern. There are 5 patterns to choose from. The selected
pattern will remain as long as power is not disrupted to the Red and Black wires.
Changing Patterns
Whenever SCANNERS™ is active, hold down the "pattern select" button for 3 seconds or more to either speed-up or slow-down the scanning motion.
This speed change will change the speed for all patterns.
Changing Speed of Scanning Motion.
Find Suitable location for installation of the Scanner on door or dashboard then clean surface with rubbing alcohol to remove oils. Remove both end
caps using small screw flat screwdriver. You can mount the Scanner using the 2 provided screws or double sided tape. Connect wires as shown in
diagram below.
Mounting the Scanner
1: Scanner does not remember pattern!
Trouble Shooting - frequently asked questions!
Memory loss will occur whenever the positive wire loses contact with the battery for a moment.
This can occure if the positive wire is attached to the wrong contact on the fuse box or some
other location in the vehicle. Try to connect directly to a line that goes directly to the battery
positive.
2: Scanner does not work when the alarm is turned on!
If you want the scanner to activate when the alarm is turned on you must connect the yellow
wire to the ground output (ignition kill) of your alarm system. DO NOT CONNECT TO THE
LED OUTPUT!. the LED output wire only provides 2-3 volts flashing and is not enough to
power the scanner. Refer to your alarm installation manual or ask your local dealer for the
correct ground output wire.
Scanner will activate when engine is turned off.
Installation without alarm system.
Patent Pending
Black
Yellow
Red
Battery Negative or Chassis ground.
Battery Positive (constant)
Ignition - Ground when engine is off (fuse box, ie.
Radio Fuse). (Activates scanner when grounded.)
Scanner will activate when you arm your alarm.
Installation with alarm system.
Black
Yellow
Red
Battery Negative or Chassis ground.
Battery Positive (constant)
Alarm system accessory output or ground output.
(Activates scanner when grounded.)
SCANNERS are designed for installation
in all automobiles equipped with or
without an alarm system.
These instructions apply to All of the Following LED SCANNERS MOdels:
VS400P, VS400B, VS400WH, VS400AQ, VS400PU, VS5000, VS5000B, VS5000PU
VS4000, VS4000B, VS4000PU