Varad IL2W - Interior 1 Watt LED Lighting System - Manual

IL2W
IM-IL2Wv1
Thank you for purchasing the Varad IL2W, dual 1 watt LED
lighting system with driver. To ensure proper use please
carefully read this installation manual prior to installation.
Installation Guide
www.varad.com
1. IL2WC - Digital Controller
2. Two 1 watt LEDs
3. Mounting bracket
4. Power Harness
5. Self tapping screws, 4pcs.
6. flush mount screws, 2pcs.
7. Tie straps, 4 pcs.
Power Harness LEDs
4 4
Digital Controller Description Technical Specifications
Physical Specifications:
Digital controller:
Height - 0.75”
Width - 1.5”
Length - 2.25”
Current Draw - 250ma
LED:
Length: 3”, Width: 1.25”, Height: 0.55”
Wires:
12’ of cable
Electrical Specifications:
Digital controller:
12v - 24v input
LEDs:
Orange - ALINGAP, 350ma, 180 degree
Red - TS ALINGAP, 350ma, 180 degree
Blue/Green/White - INGAN 350ma, 180 degree
Parts List
Function
These 1 watt LEDs are designed to create accent
lighting for automotive interiors. Applications include,
speaker boxes, footwells, amplifier racks, doors and
much more...
Precautions
To prevent fire or shock hazard, do not expose the
digital controller to rain or moisture.
To avoid electrical shock, do not open the digital
controller. Refer servicing to a factory authorized
dealer. Do not attempt to disassemble the LED or
damage will occur.
Do not bend the wire away from the
bottom of the LED or water may leak
into the housing.
Required tools
· Wire Stripper
· Wire cutter
· Assorted drill dits
· Cordless drill
· Screwdriver
Installation of LEDs
Visually inspect for a location to mount the LED. The
light dispersion pattern will vary depending upon the
location of the LED. It is recommended that you power
up the LED and move it around to determine the
location that provides the best lighting. When you have
found a suitable location, begin to install by marking
each drilling point and pre-drill each hole with a 1/8” drill
bit. Mount the LED with supplied tapping screws. Once
again making an effort not to bend the wire away from
the bottom of the LED, so no damage should occur.