NaceCare Solutions ST995 - Manual (Page 20)

SQUEEGEE REAR RUBBER REPLACEMENT
Figure 56
If the squeegee rear rubber is worn and does not dry well, it is
possible to change the drying edge proceeding as follows:
1.
Push and rotate the fixing plates.
2. Slip off the rubber blade and the rubber itself.
3. Turn the rubber upside-down and if necessary, replace it.
4. Reassemble everything repeating inversely above operations.
Adjust the squeegee height according to the rubber (see
“ADJUSTMENT HEIGHT SQUEEGEESUPPORT”).
SQUEEGEE FRONT RUBBER REPLACEMENT
Figure 57
If the squeegee front rubber is worn there is no good suction and
therefore the machine does not dry well. In this case to change it
proceed as follows:
1.
Take the squeegee off the machine (1).
2. Loosen the screws that block the front rubber.
3. Slip off the rubber blade.
4. Slip off the rubber and replace it.
5. Reassemble everything repeating inversely above operations.
ADJUSTMENT SPLASH GUARD WASHINGBASE (brushes)
Figure 58
Periodically proceed with the height adjustment of the side covers of
the base. This operation has to be carried out with the base down.
1.
Loosen the fixing knobs of the covers (1)
2. Position the covers again
3. Screw the knobs again.
It is important to remember that the rubber must skim over the floor
and be parallel to it.
REPLACEMENT OF SPLASH GUARDSRUBBERS WASHING
BASE
Figure 59
Check periodically the wear state of the base splashguards. In case of
necessity, to replace them, proceed as follows:
1.
Disassemble the covers unscrewing the knobs (1).
2. Unscrew the blades that block the splashguards rubbers.
3. Take the splashguards off and replace them.
4. Reassemble everything again following inversely above
operations.
- 19 -