NaceCare Solutions ST60BT - Manual (Page 8)

8
PREPARATION OF THE MACHINE
BATTERIES RECHARGING
In order to avoid damage to the batteries, it is necessary to avoid their complete
discharge. At the signal “0” flashing on the display of the charge indicator, the main
broom stops, whilst vacuum and traction continue to work. There is therefore enough
capacity left in the batteries to reach the recharge point.
ATTENTION: Never leave the batteries completely discharged, even if the machine is
not used. During the recharge check the level of the electrolyte and top up with
distilled water.
BATTERY CHARGE LEVEL INDICATOR
Figure 9
The battery charge level indicator is digital with 4 fixed positions and a blinking one.
The numbers which appear on the display show the approximate charge level.
4= maximum charge, 3= charge ¾, 2= charge 2/4, 1= charge ¼
0= (blinking) discharged batteries
ATTENTION: A few seconds after the meter reads “0” it will start blinking, the brush
motor will then automatically switch off.