NaceCare Solutions ST60BT - Manual (Page 7)

7
PREPARATION OF THE MACHINE
SLIDING THE MACHINE DOWN OFF THE PALLET
Figure 5
1. Close the bonnet and pull the machine forward such that it slides to the ground
along the board.
BATTERIES ASSEMBLY AND CONNECTION (battery machine only)
Figure 6
For the best mix of economy and usage we suggest fitting 2 x 12V / 140Ah batteries.
Before assembly, ensure the batteries are charged.
Assembly instructions:
1. Remove the ‘on/off’ key from the lock.
2. Open the bonnet of the machine.
3. Using a suitable lifting method, position the batteries correctly in the
compartment observing the polarity as in the attached picture.
4. Connect the bridge cables and the positive and the negative connections as in
the attached picture.
TRACTION MOTOR CONNECTION (battery machine only)
Figure 7
1 . Take the key out of the instrument board
2. Connect the traction motor cable marked with the card.
3. Insert the key again
BATTERY CHARGER CONNECTION
Figure 8
Open the front bonnet. Inside there is a female connector (see the picture) into which
the male connector, (fixed to the battery charger cables), must be inserted. The male
coupling connector is delivered in the bag containing this instruction catalogue and
must be assembled on the charger cable. Pay attention to the polarities.