NaceCare Solutions ST360 User Manual

Page 22

OPERATION CONTROL

SUCTION DOES NOT WORK

1. Make sure the connector of the suction unit is properly connected.
2. Make sure that thermal protection has not been activated (see

under THERMAL PROTE CTION).

BRUSH MOTOR DOES NOT WORK

1. Make sure the brush head was lowered.
2. Make sure that batteries are charged by checking on the indicator.
3. Make sure that thermal protection has not been activated (see

under THERMAL PROTECTION).

TRACTION MOTOR DOES NOT WORK

4. Make sure that batteries are charged by checking the indicator.
1. Make sure that thermal protection has not been activated (see

under THERMAL PROTECTION).

TOO MUCH FOAM FORMATION

Make sure that low-foam detergent has been used. If necessary, add a
minimal quantity of antifoaming agent into the recovery tank.
Keep in mind that there is more foam formation when the floor is not
very dirty. In this event, use a more diluted detergent solution.

THERMAL PROTECTIONS

There is a THERMAL PROTECTION system for the following
functions:

1. Main.
2. Suction.
3. Brushes.
4. Traction.

Should any of these functions stop, resume operation by pressing the
relevant button.
The breaker panel is built-in to the rear left of the machine.

ST360_V05-2