NaceCare Solutions RM1800F - Manual (Page 7)

7
STEP C –RINSING
In order to rinse, the nozzle must be changed from the low pressure chemical application
setting. Pull the spray nozzle towards the trigger. You can vary the spray from pinpoint to a
fan pattern.
1. Turn the foam switch to rinse 1, and
turn the rinse 2 switch to the rinse 2
position.
2. Spray water until there is a straight stream of clean water coming out of the spray
gun.
3. Spray the floor brush and set it aside.
4. Rinse the fixtures from the top to the bottom.
5. For sinks pinpoint spray the faucets and fan spray the rest to rinse, this should take 7
to 10 seconds each.
6. For urinals pinpoint spray the manual flusher then fan spray the rest to rinse, this
should take 15 to 18 seconds.
7. For toilets pinpoint clean the manual flusher, lift the seat clean hinges and seat
bottom. While still on pinpoint place the nozzle under the rim and rotate, then spray
into the bowl and around the bottom and base. Finish with a fan rinse of the fixture;
this should take 30 to 40 seconds.
8. When you are finished with the pressure hose, loop and dry the hose and hang it on
the machine. Both of the pump switches and the air compressor may be turned off at
this time.
9. Bring the floor brush out of the room and hang it on its holder on the machine
STEP D – SQUEEGEE MIRRORS AND FLAT SUFACES
If you decided to spray the mirrors at this time you can now squeegee the water off of the
mirrors and hard surfaces including counter tops and partitions.