NaceCare Solutions RM1800F - Manual (Page 4)

4
• 1 Gallon of FoamChem HD and 1 bottle of Defoamer
• Triangular stationary floor vacuum tool
• Fresh water fill hose
Preparation for work
To prepare the machine for usage follow these steps:
1. Insert the male quick disconnect coupling
(located at the end of the solution hose)
into the female quick disconnect coupling
(located on the control panel).
2. Connect the foam/rinse gun to the solution hose
3. Add clean water into the solution tank
without any chemical. Use clean buckets
only as this will be used for your rinse
water later on.
4. Verify that the chemical jug is well connected to the input of the chemical line on the
control panel and that it is not empty.
5. Make sure the Defoamer bottle is not empty and that it is connected during the use of the
machine.
NOTE: The machine was tested prior to delivery. Some minor adjustments may be
required if you require thicker or thinner foam.
Note: When the machine is received, it is set up for the chemical that is made
specifically for this machine.