Vaddio Quick-Connect Universal CAT-5 - Manual (Page 15)

WallVIEW Universal CCU Cat-5 Version
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0512 Rev C Page 15 of 20
Optimizing System Performance:
Optimizing the CCU settings will help achieve maximum performance from the system.
Difficult lighting is one of the most challenging problems video system integrators face. The
Vaddio CCU will provide the flexibility to fine tune for variables such as cable length,
day/night lighting transitions and lighting color temperature.
 Set skew control:
Adjust to afford the best picture brightness, quality and clarity. The range is 0-16. There
will typically be a range of values where the video will output a valid image. The best setting is usually
achieved with a number roughly in the middle of this valid video range.
 Adjust Y Gain: Allows for the adjustment of luminance gain up to +/- 10% as needed to compensate for a
too light or too dark image in downstream equipment.
 Adjust Iris and Digital Gain Settings: Disable Auto Iris. Set the Iris to its largest aperture (lowest ‘f’
number). Adjust the Gain until the image is too dark and then bring it back until it is properly exposed.
Exposures that require high gain settings will have a grainy video image. Adjust the detail settings for a
smoother image.
 Adjust Color to Taste: Required adjustments will vary based on the environment. The CCU allows the set-
up of three (3) scenes so settings are available for a variety of conditions. Adjust the Chroma level to taste.
Adjust Red/Blue levels next. Adjusting for skin tones or using a color chart is an easy way to find a good
baseline setup.
General Specifications
 Universal CCU Interface
Connectors  Power Connector: 5.5mm OD x 2.5mm ID
 Power RJ-45: Supplies 36V to EZIM Slot Card
 RS-232 IN RJ-45: Accepts RS-232 from ProductionVIEW or other non-daisy-
chain control systems
 RS-232 OUT RJ-45: Passes RS-232 and Sync video feed to camera EZIM
 Tally: 2-Pin Phoenix type spring cage connector
 Video From Camera RJ-45: Accept differential video from EZIM Slot Card
Video Outputs:
 HD-YPbPr on DE-15-F connector
 HDMI on HDMI-F connector
 HD-SDI on Edge Mount Carrier Class, Gold BNC-F (supports 3Gb/s Single Link
1080p/60 HD-SDI)
Camera Settings
Switch All switches should be in the down position for default.
 Dip Switch 1: Put up to allow Scene A to load upon start-up or boot up.
 Dip Switch 5: Put up to access LCD Display Menu settings including
Display Mode (Negative Mode-Default or Positive Mode), Bias (Brightness)
and Contrast.
 Dip Switches 2, 3, 4, 6, 7 & 8: NA for HD-20, HD-19 and HD-18
Video Adjustments Y-Gain (luminance gain) for fine tuning over longer cable distances
Skew for distance compensation:
CAT-5 Cable
Maximum Distance Up to 500’ (152.4m)
Power Supply 36 VDC, 2.78 Amp
Dimensions 1-RU Rack Mount - 1.72” H x 18.93” W x 7” D (43.7mm x 480.1mm x 177.8mm)
Rack Ears Included
 EZIM (EZCamera Interface Module) Slot Card
Connectors Two (2) RJ-45 Connectors
For Power and HSDS Video
Note: Specifications and pricing are subject to change without prior notice or obligation.