TurboChef Technologies Encore EN - Manual (Page 18)

12 INFO MOdE
Load Menu ON/OFF:
The Load Menu screen allows the operator to upload
and/or download new menu settings from a uSb
drive or smart card. Turning “Load Menu” off will
prevent access to the Load Menu screen when the
operator is viewing the Info 2 screen. See page 13 for
more details.
Network Setup:
using oven Connect (page 4) requires each oven
to be networked. For help determining the correct
network setup information, contact your network
administrator.
From the network setup screen, the following infor-
mation may be entered to configure the oven for
networking:
- IP Address
- Mask
- Gateway (GW)
- Domain Name Server (DNS 1)
- Alternate Domain Name Server (DNS 2)
Each number set can be edited in three-digit strings:
1. To edit the first string, press the Down key
and then type in the first three digits.
2. Press the Down key again and enter the next
three digits.
3. repeat until all digits have been entered for
each field.
4. Press “Save.”
If DHCP is turned on (top-left corner of screen),
the oven will automatically be assigned an IP address
when connected to a local area network (if an IP
address is available). In most cases, TurboChef
recommends leaving DHCP off to ensure the IP
address on the oven does not change.
Auto Off - ON/OFF:
“Auto off” is a feature that turns the oven off
automatically at a specific time of day. To set the
“Auto off” time, see below and page 13.
Auto On - ON/OFF:
“Auto on” is a feature that turns the oven on
automatically at a specific time of day. To set the
“Auto on” time, see below and page 13.
demo Mode ON/OFF:
Demo Mode is a feature used to demonstrate the
cooking features of the oven without turning on the
heaters or microwave system. Demo Mode must
remain off during regular operation.
Set date/Time
From screen 2 of the Info Mode, select “Set Date/
Time” to set:
- Date and time of day
- Auto-on time
- Auto-off time
An accurate date and time of day are critical for using
“auto-on” and “auto-off” (see above for details). They
also help ensure the accuracy of diagnostics and fault
condition reporting.
NoTE: The clock will not automatically update for
Daylight Savings Time.
NoTE: The clock is 24-hour (8:30 p.m. = 20:30).
NoTE: The oven will not retain the date and time
if left unplugged for two or more weeks.
To set the date and time of day (see illustration above),
1. use the keys to the left and right of the “date/time
of day” field to move the cursor between digits.
2. use the number keys to enter the month, day,
and year, followed by the hour and minute.
3. Select “Save” to save your changes or press the
back/Stop key to cancel.
Continued on next page...
DHCP
OFF
De -
Fault
Network Settings
SAVE CANCEL
IP:
Mask:
GW:
DNS1:
DNS2:
MAC: 00:19:96:00:28:5D
NAME: ENCOREOVEN
169.254. 1. 1
255.255. 0. 0
169.254. 1. 1
169.254. 1. 1
169.254. 1. 1
SAVE TEMP 1
SET DATE/TIME
MM/DD/YY HH:MM
< 0 1 /01 /00 14:45 >
AUTO ON TIME
HH:MM
< 05:30 >
AUTO OFF TIME
HH:MM
< 16:00 >