TurboChef Technologies Encore EN User Manual
Page 12
6
CLEANING
A
Step 7
Step 8
Step 10
Step 9
Step 11
Step 12
Step 6: Remove Large Food Particles
• The heating element can be lifted for cleaning underneath.
Do NoT attempt to clean the heating element.
• Use a food vacuum or damp towel to remove large
particles from the oven cavity.
Step 7: Clean the Oven Cavity
Do NoT spray TurboChef ® oven Cleaner into the holes in the oven cavity.
• Apply Oven Cleaner to a towel or nylon scrub pad and clean the top, sides, and
bottom of the cavity.
Do NoT apply excessive pressure to the waveguide covers (A), located on
each side of the cavity.
• For stubborn stains, sparingly spray Oven Cleaner on the stain.
• Allow the Oven Cleaner to penetrate the stain for five minutes, then wipe clean.
Do NoT use a hose or water jet for cleaning.
Step 8: Wipe down the Oven Cavity
• Wipe down the oven cavity with a damp towel.
• Dry the oven cavity with a dry towel.
Step 9: Clean and dry the Oven door
• Clean the oven door with Oven Cleaner and a nylon scrub pad.
• Wipe the oven door with a damp towel.
• Dry the oven door with a dry towel.
Step 10: Apply TurboChef ® Oven Guard
• Spray TurboChef ® Oven Guard onto a dry towel.
• Wipe the cavity walls and the inside of the oven door.
Do NoT spray oven Guard into the oven or apply to the heating element.
Step 11: Reinstall Components
• Reinstall the cavity filter (if present). Be sure to align the top-left post on the
back of the filter with the top-left hole on the back cavity wall. This will ensure the
other posts on the back of the filter fit into the wall.
• Reinstall the jetplate and the wire rack.
Do NoT operate the oven without the bottom jetplate installed. Doing so may
damage the oven.
• Close the oven door.
• Reinstall the filter, or replace it with a new one if the mesh is deteriorated,
has large openings, or has started to dislodge from the frame.
Step 12: Clean the Oven Exterior
• Wipe the oven exterior with a damp towel.
• Remove the panel beneath the door, remove any large food particles from the panel,
and wipe it with a damp towel.
• Reinstall the panel beneath the door.
Do NoT spray chemicals into any openings, such as the louvers on the side
panels or the rear vent catalyst housing.
• The oven is ready to turn on.
Step 6