Napoleon Fireplaces GVF42 - Manual (Page 25)

25
W415-0379 / E / 04.24.12
COMPONENTS
REF PART NO. DESCRIPTION
1* W357-0001 PIEZO IGNITER
2 W662-0001 NATURAL GAS OXYGEN DEPLETION SENSOR SYSTEM
2 W662-0005 PROPANE GAS OXYGEN DEPLETION SENSOR SYSTEM
3* W680-0004 THERMOPILE
4 W725-0030 NATURAL GAS VALVE
4 W725-0031 PROPANE GAS VALVE
5* W385-0430 NAPOLEON LOGO
6* GD-660 STANDARD WALL SWITCH & 20FT OF WIRE
7 GL-633 LOG SET
8* W361-0079 GLOWING EMBERS
9* W550-0001 CHARCOAL EMBERS
10* W550-0002 CHARCOAL LUMPS
11* W361-0014 VERMICULITE
12 W135-0150 BACK - LOG #1
Contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normally
all parts can be ordered through your Authorized dealer / distributor.
FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE WILL BE
REQUIRED TO HONOUR THE CLAIM.
When ordering replacement parts always give the following information:
•
Model & Serial Number of appliance
• Installation date of appliance
• Part number
• Description of part
• Finish
* IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FOR
FURTHER INFORMATION, CONTACT YOUR AUTHORIZED DEALER.
41.1
FAILURE TO POSITION THE PARTS
IN ACCORDANCE WITH THIS
MANUAL OR FAILURE TO USE ONLY
PARTS SPECIFICALLY APPROVED
WITH THIS APPLIANCE MAY
RESULT IN PROPERTY DAMAGE OR
PERSONAL INJURY.
!
WARNING
10.0 REPLACEMENTS
9.2 CARE OF PLATED PARTS
6.1
If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.