Antunes, AJ SE-4200/4400 - Manual (Page 4)

SE-4200/4400 WATER FILTRATION SYSTEM
4 P/N 1010852 Rev. C 04/06
The following warnings and cautions appear
throughout this manual and should be carefully
observed.
• Turn the unit off, disconnect the power
source, and allow unit to cool down before
performing any service or maintenance on the
unit.
• The equipment should be grounded accord-
ing to local electrical codes to prevent the
possibility of electrical shock. It requires a
grounded receptacle with separate electrical
lines protected by fuses or a circuit breaker of
the proper rating.
• All electrical connections must be in accor-
dance with local electrical codes and any
other applicable codes.
• WARNING, ELECTRICAL SHOCK HAZARD.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR
DEATH.
- Electrical ground is required on this appli-
ance.
- Do not modify the power supply cord plug.
If it does not fit the outlet, have a proper
outlet installed by a qualified electrician.
- Do not use an extension cord with this
appliance.
- Check with a qualified electrician if you
are in doubt as to whether the appliance is
properly grounded.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agency or a similarly qualified person.
• This equipment is to be installed to comply
with the local plumbing code and any other
applicable code.
• Water pressure must not exceed the mem-
brane burst pressure of 7 bar (100 psi). To
reduce water pressure, install a water pres-
sure regulator and set the water pressure to
suit application. Note that trans membrane
pressure (inlet water pressure) must be .5 - 2.5
bar (7 - 36 psi).
IMPORTANT SAFETY INFORMATION (continued)