Warning – Alliance Laundry Systems H2641 User Manual

Page 24

Operation

800536

Step 4: Set Fabric Selector

Set regular loads at NORMAL or PERM PRESS. Set
delicate loads at DELICATE.

Figure 19

Step 5: Set WASH/RINSE Temperatures

Set at HOT (COLD rinse), WARM (COLD rinse) or
COLD (COLD rinse).

NOTE: Always follow manufacturer’s care labels.

Figure 20

Step 6: Insert Money

Place coin(s) in slide and carefully push in as far as
possible and then pull slide out as far as possible. After
IN USE light comes on (indicating start of cycle),
press the PUSH-TO-START button.

Figure 21

Indicator Lights

IN USE

This light will remain on while washer is in use.

DOOR LOCKED

This light will come on after the start button has been
pushed and the washer door has locked. It will remain
on until the wash cycle has ended.

FINAL SPIN AND TUMBLE

This light will come on at the start of the final spin and
remain on until the wash cycle has ended.

CLOSE DOOR

This light will come on if door is not closed tightly.
Firmly push door until light goes out.

IMPORTANT: If washer fails to operate properly
after installation, make sure electrical service and
water supply faucets are turned on. Are all the
controls properly set? Have a qualified service
person refer to the wiring diagram (located inside
of cabinet) and check for broken, loose or incorrect
wiring.

NOTE: Once a cycle has started, the door can only
be opened by first unplugging the power cord and
waiting one minute.

The washer will stop (pause) shortly before the first
spin and final spin.

H171I

H170I

W297I

H171I

H170I

To reduce the risk of bodily injury, do not
remove laundry from washer until all
lights are out, and all moving parts have
stopped.

W092

WARNING